|
Post by tachout on May 23, 2012 10:22:13 GMT -7
If you had access to have custom parts made for your project I would be interested in hearing what you would be looking for. I have been asked by a couple of my clients that do machine work, or have a small job shop, if they were to make aftermarket parts for our industry, what would be want. So far top things I hear are the following:
Harness Bar Custom Bar to replace the Top when the top is out. Crossmember to change out the 700R4 to (TH400,TH350,4L80...) Front Brake Plates Rear Suspension Parts Dana 36 to Dana 44 Plate center console plate The interior ribs on the door panels that hold the panels in place would be a great idea. if you make a plate with the ribs in aluminum that could be bonded to the door panel.
Please add up your ideas. Would love to hear what you guys would want.
|
|
|
Post by iZabell on May 24, 2012 10:45:22 GMT -7
There is a certain vette on here that needed some custom parts made . . .
|
|
tbiga
Junior Member
Posts: 129
|
Post by tbiga on May 24, 2012 13:43:42 GMT -7
There is a certain vette on here that needed some custom parts made . . . Them are some fancy looking cup holders.
|
|
|
Post by highpockets on May 24, 2012 21:13:05 GMT -7
I wish ! Actually fancy fire extinguisher holders. Thanks again Adam,you did a great job and the engraving was a nice surprise !
|
|
|
Post by 500hp406 on May 25, 2012 8:12:00 GMT -7
I saw them when I was at Vinces last week....Very, very, nice.... If I could just find a reason? ?
|
|
|
Post by unreal on May 26, 2012 10:27:38 GMT -7
Rear spindles for c6s to allow a 15" wheel for a decent price.
|
|